This helps keep the sides the same length and helps make the frame square. Route both side pieces of wood at the same time.Depending on the diameter of the router bed, depends on the distance of the guide. Clamp a piece of wood across as a guide for the router.We will want to route this part for the rabbett. Mark with a pencil the width of the wood at the end of the side pieces.Side pieces = backboard height + wood thickness + 10.Top and bottom piece length = backboard length + wood thickness + 10.I made the sides very slightly longer (10mm) so allow the backboard to hide behind the frame. Using the backboard to define the size of the shooting gallery (my back board is 1220mm x 610mm), cut the side wood accordingly.This allows the NERFs to drop to the bottom (assuming they don't bounce back!) and be collected in the 'trough' at the bottom. The shooting gallery is basically a set of shelves with the two shelves which hold the targets only partially deep.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |